Printable View
Yes, I have this in two areas of the forum....just trying to spread the word!
I'm have suddenly found myself in a situation that requires a beam style torque wrench that measures in inch-pounds. I don't want to drop the coin to buy a new one since I'm only going to need the beam style for this one project. Can anyone around help???
I cant remember if autozone or o'rieleys lones out torque wrenches or not but you can check there. A torque wrench is actually a pretty handy tool to have. $40 will buy you a "decent" one.
He was looking specifically for a beam type in inch pounds. Not a clicker type like is sold most everywhere.
http://www.jcwhitney.com/wcsstore/jc...7931G_SW_1.gif
This picture is from JCWhitney.Com and is $13 from them. It goes 0-600 inch pounds.
Why? :confused:Quote:
Originally Posted by Radio-Active
beam types arent all that accurate. If you are going to spend the money you might as well get a good one. The $40 I was telling him was for a beam type anyway... Craftsman sells them for $30 or you could spend an extra 40 and get an actual accurate wrench. Its all up to what you want anyway. I have a $200 dollar torque wrench I rarely ever use, but when I do it come in handy. If you work on cars a lot you get the feel for how much torque you are putting on something, even without a torque wrench
An example of where you might want a beam style torque wrench:Quote:
Originally Posted by sammm
Sometimes you want to find out where a torque tamer type sprocket clutch is going to slip, so that you can adjust it for the proper amount of torque before the sprocket starts to slip. In this case the clicker will not read like a scale and will not be of any use.
"Inch Pounds" you brutes! :punchout:Quote:
Originally Posted by rootdown_53
Yeah, and I had a hard time finding one on the internet that was less than 600 inch pounds(50 ft-lbs).
He probably was wantin in the 0-150 in-lbs range.
well 1 foot pounds = 12 inch pound force and I know that craftsman starts at zero because I used to have one. The problem is those craftsman or for that matter any cheap beam style torque wrench is not going to be accurate. What are you trying to torque anyway?
I've got one you can use
I was using my inch pound torque wrench yesterday when it stopped torqueing. It still worked okay as a wrench to unbolt, but not to tighten, which is when I usually need to know the torque. Headed off to Harbor Freight for a new free replacement, no questions asked.
Why do you need/use a torque wrench to remove a fastener? :confused:Quote:
Originally Posted by cam76034
South American torque wrench?Quote:
Originally Posted by sammm
nobody local sells in/lb torque wrenches anymore because there is very little market for them. I got mine which is a KB 60 in/lb for $40 from an axle shop when i built a differential for a friend. In/Lb beam are the only torque wrench you should use to set up a bearing because you have to creep up on specs. when something like a bearing is set you have to use a beam because the click wrench won't click at the right spec because the bearing is slowly spinning. you can borrow mine if you still need one just pm me.
By the way sears wrenches don't register below 15 lb/ft and Snap On makes a digital clicker that goes from 10 in/lb to 150 ft/lb for $260 but still beams are the only thing you should use if there is bearing preload being measured such as a transmission or differential.
Sears sells an in/lbs torque wrench.
This is the one I have.
when i was shopping for mine after sears was bought from k-mart and the warranty scandal was going on they went out of store stock and i was exclusively searching for a beam to set bearing preload