-
NA ('91) Parts For Sale
Car is a '91 and is pretty basic, nothing fancy.
Here is what I have removed from the car so far and more will come.
SPARE TIRE/WHEEL $20
A/C CONDENSER, LINES, DRYER, AND COMPRESSOR (not sure if it works) $50
http://i172.photobucket.com/albums/w...o/DSC06246.jpg
DRIVER'S AND PASS WINDOWS $40 EACH
http://i172.photobucket.com/albums/w...o/DSC06250.jpg
DRIVER'S 1/4 WINDOW $30
DRIVER'S AND PASS MANUAL WINDOW MECHANICS $15 EACH
http://i172.photobucket.com/albums/w...o/DSC06255.jpg
DRIVER AND PASS SEAT BELT AND LATCH $10 EACH
http://i172.photobucket.com/albums/w...o/DSC06259.jpg
VERY NICE CONV TOP FRAME $75
http://i172.photobucket.com/albums/w...o/DSC06260.jpg
AIR BAG SENSORS (good) $40 for all
http://i172.photobucket.com/albums/w...o/DSC06264.jpg
'91 1.6 WITH LOW COMPRESSION BUT IN RUNNING ORDER w/flywheel and clutch and everything bolted to it $500
http://i172.photobucket.com/albums/w...o/DSC06358.jpg
http://i172.photobucket.com/albums/w...o/DSC06359.jpg
http://i172.photobucket.com/albums/w...o/DSC06360.jpg
http://i172.photobucket.com/albums/w...o/DSC06361.jpg
If motor sells then I am installing a Mitsubishi 4G63 turbo motor with a Toyota trans but if it doesnt then I am building a Spec Miata out of the car. This will determin what else comes off of the car.
-
Its funny, I have most of these parts sitting in my garage also from lightening mine.
-
I need a cup holder...
do you want to sell one??
-
Where is Providence Village? I might be interested in one or both of the window mechanisms. Mainly passenger, but I'll have to go over my car and find out.
-
I dont have a cup holder, sorry.
Providence is east of Denton on Hwy 380
MAP
I have a shop there in Cross Roads. All of the are is new and really doesnt show up on the photo maps yet. Either way, I am not far from Frisco, McKinney, Denton, The Colony. I can ship items or meet people around town sometimes. I am all over the place as a field technician.
-
I busted my left turn signal today.. have one of those?
-
I need a cheap bumper and hood.
-
I am keeping the car so I need the turn signals. I am building a race car project. As it says in my original post, "If motor sells then I am installing a Mitsubishi 4G63 turbo motor with a Toyota trans but if it doesnt then I am building a Spec Miata out of the car. This will determin what else comes off of the car." If I sell the motor I will have another block, a tranny, driver shaft, and other engine related items for sale. No matter what set-up I end up going with I will be replacing the rear end at some point so the '91 rear end and axles will be for sale eventually.