Printable View
http://www.tyjames.com/diff.jpg
Came into rattlesnake at MSR a little too hot, had to straddle the strip, and one of the bolts for the PPF was too low and made contact, ended up causing this :-/
Does anyone have an alum housing laying around, or know someone who does?
I think that can be welded back together.
It'll buff right out.
Normally I'd agree, but this might also require some JB Weld before buffing.Quote:
Originally Posted by jrj512
Just safety wire.Quote:
Originally Posted by TexasStig
I thought about welding it, but it broke at the engineered breaking point, I don't want to compromise that, so I think a new housing is a good idea.Quote:
Originally Posted by sammm
The Parts Group seems to have some. http://www.partsgroup.com/store.aspx...veTrain&Page=0
I have not checked locally.
Is it a 1.6 diff? What's it worth? I have an lsd with a bad front bearing.
It's a 1.8 diff.
Duct tapeQuote:
Originally Posted by jeff_man
If all else fails a good weld can fix that, but welding aluminum can get tricky
If done correctly, the welded spot would be stronger than the original.Quote:
Originally Posted by mach1
I think that is the point...that place is designed to break there incase this happened. If he welds it it might break somewhere worse.Quote:
Originally Posted by sammm
X2, exactly.Quote:
Originally Posted by 00MugenS2
I believe they are $150-ish for parts group? Give them a call, I bet they have some.
Seems a bit high, I think I may just call some yards, you can get a whole rear diff for $150 or less.Quote:
Originally Posted by Vashthestanbeto