Mazdaspeed Undertray

This may be an odd request, but would someone that has a stock MSM undertray mind taking it off for just a bit so I could take some measurements and compare it to the standard NB tray? I could probably do fine modifying it just from putting it up under the car and marking it up, but it would be a huge help to see an MSM tray up close and compare. I'll throw in a drink or something for the trouble! And if I can get it to fit, I'll write up a tutorial for modifying the stock undertray to fit the MSM.

Rosenthal has nice pictures of both. The MSM unit is the stock unit with some cuts.

MSM:
http://parts.arlingtonmazda.com/prod...2d111A%29.html

Normal 1990-2005 Miatas:
http://parts.arlingtonmazda.com/prod...2d111F%29.html

http://parts.arlingtonmazda.com/prod...41353_zoom.jpg
http://parts.arlingtonmazda.com/prod...15699_zoom.jpg

Thanks. Those pictures are actually why I chose to try it out. I should be able to do it just off those and the car, but I just thought I'd put it out there to see if I could take a look at one in person.

What measurement do you need? Mine is off the car, so this should be pretty easy. I think I cut the section where the IC pipe goes through though. It was a pain to get it in and out.

Charging twice the price for less material? How very Porsche-esque of them

Quote:

---

Originally Posted by ILoveofframps

What measurement do you need? Mine is off the car, so this should be pretty easy. I think I cut the section where the IC pipe goes through though. It was a pain to get it in and out.

---

http://i62.tinypic.com/2yjvuw9.jpg

Not sure how I missed this post. I marked the measurements, but they are (1) the distance from the slot on the right side to the front of the tray, (2) distance from the front of the tray to the edge of the IC piping cutout and the radius or diameter of the cutout, (3) the distance from the front corner to the top of the notch, (4) the distance from the front corner to the horizontal part of the notch (by the screw holes).

That should do it. Hopefully you still have it off, but if not this will be here for later.

One more I missed... the length of the slot on the right before it reaches the IC piping cutout.

I just got the undertray unburied, so I'll try and get those numbers for you tomorrow if you still need them.

Quote:

---

Originally Posted by ILoveofframps

I just got the undertray unburied, so I'll try and get those numbers for you tomorrow if you still need them.

---

Thanks! I'd appreciate it!