Cold Side Intake Finished

Quote:

---

Originally Posted by gabkwong

What is the setup you used to plug in the air temp sensor? The hose is 2.75" diameter!?

---

2.5-2.75, the TB is 2.5 and the maf is 2.75.

as for the temp sensor. its the one in the elbow, punch a hole the size of the factory rubber grommet and stuck it in there, fit perfect. not sure if most proper way to do it, but it runs fine and not throwing any codes.

What year id your car??

Since this thread is a year and a half old I have no idea if these people are still active. I can tell from the picture it is a 99-00 though.

Do you have to extend wire of MAF?

Looks great. What year is your Miata??

Quote:

---

Originally Posted by Mikey3229

What year id your car??

---

Quote:

---

Originally Posted by Majik

Since this thread is a year and a half old I have no idea if these people are still active. I can tell from the picture it is a 99-00 though.

---

Quote:

---

Originally Posted by Mikey3229

Looks great. What year is your Miata??

---

I'll try this time Majik. The OP's car is a 1999. Majik and I can tell because of the Sapphire Blue Mica paint and the strut tower brace. This tells us the car is a 10th Anniversary Edition, also known as a 10AE. I also looked at the OP's profile.