power steering sensor wire

[Steve E]

So where does the sensor wire on a 97 ps rack connect to the harness? Shop manual is no help in converting a manual to ps. But maybe it is not required.

[OZMDD]

I'm familiar with the wire that runs to the ps pump, but I guess I'm forgetting about one that runs to the rack. Rogue?

[Mr. Miatie]

What would this wire do at the rack?

[Rogue]

There is no wiring to the rack, he's talking about the Pressure switch wire going to the ECU.
Never had an issue with leaving the PS wire just unplugged.
I can't imagine it would make much of a difference to a pre-OBD-II ECU.
William converted his Rpack to an STO, so he may have insight.

[sammm]

^What's the job of the pressure switch going to the ECU?

[POS Racing]

^What's the job of the pressure switch going to the ECU?

The pressure switch is wired into the ECU to raise the idle when the wheel is turned.

[sammm]

Thanks.

[OZMDD]

Mick is smart!!

[Steve E]

Thanks ya'll. Yes i did mean to say pump. Ecu is the next mointain on this climb...