I'd avoid the route that leads to Magma stepping on your head.
I have already changed the rear shocks. Piece of cake. (4.5 hours worth of cake.)
Now, I can not get the old front shocks out of the car. I have the ^^ garage instructions. One persons say to remove the upper ball joint. One says to use a spring compressor while the shocks are still in the car. And, one says to remove the big bolt attaching the upper A arm to the frame. None of these seem to be a good alternative to me.
How does the members here get the old shocks out?
On the track, I am fearless.
If you were as slow as me, you wouldn't be afraid either.
1994 M Edition
CSP 67
I'd avoid the route that leads to Magma stepping on your head.
San Diego method prevails around here...
http://www.good-win-racing.com/mazda...tallation.html
Maybe 4 wheels aren't so bad after all... wickett.org
It only goes to show when people can no longer discriminate on the grounds of race, religion, or sexual orientation, they can improvise and still find someone to hate. - Dave Moulton
Thanks guys, I off to the shop to get'er done.
On the track, I am fearless.
If you were as slow as me, you wouldn't be afraid either.
1994 M Edition
CSP 67
They're all wrong. Andy Hollis' method (as documented on the board) is sooo much easier. Remove the long through bolt on the upper A-arm and be done with it.
When we did jigger's car, we did one front shock using the San Diego method, and the other using the Hollis method. No comparison - the Hollis method was easier. No breaker bars - or friends for extra leverage - required.
Iain
"We don't stop playing because we grow old, we grow old because we stop playing." - George Bernard Shaw
I'm working by myself. No one to step on me. I've got one shock out, but I think I'm about done for today. I'll hit it again bright and early in the morning, about 10 or 11.
The Hollis method must be easier than it looks. I may try that on the right side.
On the track, I am fearless.
If you were as slow as me, you wouldn't be afraid either.
1994 M Edition
CSP 67
Yeah the Hollis method is good for one person. Just take the splash gaurd down halfway to make it easier.
Weird. I had no problem doing the San Diego method by myself the last time I had the suspension out. Couldn't get the long bolt out.
Thomas
V-to-the-Dub
All finished.
I did the Hollis method, long bolt at the top of the upper A arm, on the right side. It was a lot easier than the San Diego method. The bolt came out, and went back in, with no problems and not much effort. I could not get my torque wrench on the nut, so I torqued from the head end of the bolt. I hope it works out the same.
Also, I installed my new FM 25.4mm front sway bar. Very easy when done at the same time as the shocks.
Now, time to go terrorize the neighborhood, I mean a test .....
On the track, I am fearless.
If you were as slow as me, you wouldn't be afraid either.
1994 M Edition
CSP 67