Results 1 to 3 of 3

Thread: need a bit of help...

  1. 04-20-2010, 01:30 PM #1
    larryd
    larryd is offline
    Engine Builder
    Join Date
    Dec 2009
    Location
    corinth, tx
    Posts
    60

    Default need a bit of help...

    after my accident last month, thinking it was just superficial stuff, found that the front end of the fender wing (part of the unibody that he fender bolts on) is badly bent up and the left side of the radiator xmember was bent down and back. i don't think i can do it myself. rogue, do you have the stuff needed to do this or do i need to go to a large body shop to get them to straighten this out? I finally have all the parts needed but have to get this taken care of before bolting everything back on. thanks!
    Reply With Quote Reply With Quote
  2. 04-20-2010, 01:52 PM #2
    jrj512
    jrj512 is offline
    Driver jrj512's Avatar
    Join Date
    May 2006
    Location
    Arlington, TX
    Posts
    9,916

    Default

    Rogue can go cut a section out of a good car and replace the bad section on your car. I cannot even see the seams on mine, even under the hood. It is just a matter of finding a good donor car.
    Reply With Quote Reply With Quote
  3. 04-20-2010, 05:33 PM #3
    larryd
    larryd is offline
    Engine Builder
    Join Date
    Dec 2009
    Location
    corinth, tx
    Posts
    60

    Default

    well i guess i just need to get with the man! rogue you out there?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules