Results 1 to 2 of 2

Thread: I had to have that wheel in my hands.

  1. #1

    Default I had to have that wheel in my hands.

    It was so cool here in Dallas yesterday as we had two inches of snow twenty miles away.
    But I just had to have that wheel in my hand.
    I waited until 1:00 PM and the temperature had risen to 59.
    I pulled her out of the garage after a long winter's nap, checked the oil, and she started on the first attempt. Disregarding safety I wore shorts, a t-shirt, and no gloves or helmet.
    The engine was running at full throttle as I slipped her into gear, gripped the wheel and we were off.
    I almost didn't make the first turn as the engine insisted on staying at redline! But I did make it.
    Down the next straight at full throttle and into the ninety degree left turn, then off again with the RPM's never dropping!
    It stayed this way for about an hour and I was sweating the results.
    I finally covered all the well know ground. Enough of this already and I killed the engine after an extended run.
    Now, a nice cold beer on the patio after I pushed the mower back into the garage.
    5 days and counting until the adventure

    BTW, she's almost needing new tires and an oil change.
    Does anyone have a tire recommendation or know if using regular Mobil1 instead of the fancy Sears branded mower oil will hurt the engine?
    Jack "Rude Dog" Hays
    I'll See You On The Dark Side Of The Moon

  2. #2
    Driver OzCop's Avatar
    Join Date
    Oct 2004
    Location
    Highland Village, TX
    Posts
    405

    Default

    I have used Mobil 1 in my 25hp rider since new in 2000. Never a problem, so I say go fer'it...
    OzCop
    MSM
    "It's never too late to have a happy childhood!"

Similar Threads

  1. Oooh... getting used to a Driving Wheel...
    By Treibenschnell in forum Racing Simulations
    Replies: 5
    Last Post: 02-23-2005, 07:56 PM
  2. Wheel offset and tire choices.
    By OUTRACE in forum Miata Tech and Chat
    Replies: 10
    Last Post: 08-18-2004, 08:00 AM
  3. Needs Help Replacing Wheel Stud
    By gabkwong in forum Parts is Parts
    Replies: 3
    Last Post: 07-25-2004, 07:16 PM
  4. Wheel weight - Pros & Cons & Questions
    By sammm in forum Miata Tech and Chat
    Replies: 3
    Last Post: 03-28-2004, 06:55 AM
  5. Only one wheel locked???
    By POS Racing in forum Miata Tech and Chat
    Replies: 13
    Last Post: 03-10-2004, 09:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •