a arms

[patf]

after a little excursion due to a durango, i need an upper and lower a control arm for the passenger side of a 93. anyone have some bits laying around or know of a yard they can direct me to?

tia

[Bacon]

Check out Mazda/Nissan Heaven. I got an a-arm from them a couple years ago for $50.

[channelmaniac]

There are a few down on 180 near Loop 12 too that would be a lot closer to you.

Also, call Gary at http://www.trackdogracing.com to see if he has any on a parts car.

RJ

[patf]

thanks guys! i got a quote from planet miata but they only had the upper.

[Ataim]

http://www.partsgroup.com/default.as...&recurseB=true

Try them?

[MadMerv]

I'll give you an upper, but are you sure it is bad? The long bolt will usually bend before the a-arm gives way.

[Dave04]

I'll give you an upper.

but what about the car part?

[patf]

madmerv

yea, its bad. the right front went over a storm drain
culvert and twisted things up a bit out at the ball joint.

I'll take you up on it

[nealb]

contact Bob Stretch

he's bound to have the stuff you need

fixrim @ aol.com

[MadMerv]

madmerv

yea, its bad. the right front went over a storm drain
culvert and twisted things up a bit out at the ball joint.

I'll take you up on it

I will bring an a-arm and bolt to my office(Euless) tomorrow.....

[ray_sir_6]

contact Bob Stretch

he's bound to have the stuff you need

fixrim @ aol.com

Hey now, that's my contact.

But yeah, Bob has enough parts to make 7+ fully functional Miatas, so he should have thos parts, and at a great price.

[MadMerv]

I have an upper a-arm and bolt in the trunk today....free if you still need it.
Merv

[patf]

thanks for all the offers. i have everything now. ended up with an order from tire rack (bilstiens) and mazda south to finish the shopping list.

thanks again for the offer mad merv, but when i was over at one of the yards getting the lower and they had a stack of the uppers so i grabbed on there.

the upper bolt was bent, had to sawzall off and then heat to remove.. ugh.

[MadMerv]

thanks for all the offers. i have everything now. ended up with an order from tire rack (bilstiens) and mazda south to finish the shopping list.

thanks again for the offer mad merv, but when i was over at one of the yards getting the lower and they had a stack of the uppers so i grabbed on there.

the upper bolt was bent, had to sawzall off and then heat to remove.. ugh.

I knew you would need to. That bolt always goes first. I guess I'll take this a-arm and bolt back to the barn...................

[patf]

hopefully as long as you have one, you will never need one.

thanks again