Printable View
I'm trying to install my front crank seal and I have about 0.5mm of the seal sticking out and I can't get the rest in all the way. Does anyone have the front seal installer or any equivalent I can borrow? I'm willing to pay the cost of the installer as a deposit and a few bucks for your time. Or if you have any ideas on how I can finish this, I'd be grateful. :confused:
I have it but didn't find it particularly special. A large socket should work just as well.
Only problem is I don't have a large socket. I suppose I could buy one but I thought I'd check here first. Can I borrow yours? Or buy it off of you? :D
all you need is a 3/8 extension and a hammer and your done.
Hey Titus what are the dimensions on the tool?
May save tinman831 a trip to Oklahoma. ;-)
Hey isn't this the seal where you can use a piece of PVC pipe? Or is that the Cam seals? Haven't done a timing belt change lately.
Piece of PVC with 1-7/8" OD works great. Probably 1-3/4" pipe, but I'm not sure. I put some black tape on the edge that was contacting the seal before I tapped it in.
external diameter: 50mmQuote:
Originally Posted by POS Racing
Lip: 36 mm
Internal Diameter: 27 mm
Pass through hole: 14.5 mm