Printable View
Is the power steering fluid something that should be changed at regular intervals? I notice that sometimes on longer slaloms the wheel feels like it momentarily gets heavier like going from power steering to manual steering and then back. Does the p.s. fluid need to be checked/changed like brake fluid etc? I figure mine it might be dirty or low or it might be unrelated.
Elderly Miatas are know for the steering stalling issue on slaloms. My '92 did it a few times, I changed the fluid and it still would do it on occasion, fixed it at an evolution driving school where I was told to make smother inputs, which also help. :drive:
You may also want to change your belts out with some new and see if you may also be having some belt slippage issues.
I get this on occasion, too. From those to which I have talked, there is not a lot you can do about it.
LOL, all my car problems seem to be tracable back to the nut behind the wheel. I'll check the fluid level and belts to day and see, it's not really frequent maybe once an autocross or so.Quote:
Originally Posted by POS Racing
I just did away with the fluid altogether. ;)
......and put a manual rack.
After driving Apex2Apex's 94R with manual rack I'd rather go back to FWD than go through that. I can't even imagine how bad it is with the the slower ratio power steering rack.Quote:
Originally Posted by Rogue
Dang... now that I've actually been to an auto-x I can't imagine using manual steering... that would kill me! http://smiliesftw.com/x/noesaway.gifQuote:
Originally Posted by Rogue
Especially with your little girlie arms! ::Curls::Quote:
Originally Posted by MadMonkey
;)
You wouldn't say that to my face! :DQuote:
Originally Posted by POS Racing
with your girlie voice...
http://smiliesftw.com/x/gayhaaay1.gif
I'll just chime in with my non-Miata experience (since my Miata does not have this problem). I've had the same thing happen in several vehicles over the years and it's basically due to an undersized pump. It's a hydraulic problem, not a fluid quality problem. So POS's advice is good; by slowing down your steering inputs, you are reducing the demands on the system and you avoid the power/no-power/power steering effect.Quote:
Originally Posted by CosmosMpower
Did you search the pointy board? I didn't but I'll bet there's better info there. You're welcome :rolleyes:
DING DING, round 2 ::Banana::Quote:
Originally Posted by MadMonkey
Why is it referred to as the "pointy board"?
rlt
http://forums.dfwmiata.com/showthrea...ointy+board%22Quote:
Originally Posted by rob76turbo
Gee - I thought you two had met before.Quote:
Originally Posted by MadMonkey
So, on a similar note related to the title......I went to Hallett on July 22. After every track session I had power steering fluid all around the reservoir. As the day progressed, more and more fluid was boiling over.
Have any of yall changed the power steering fluid? Is it difficult? I've never looked to see what is required to do so.
Believe it or not, when I started AutoX I was driving a 1991 Honda Civic sedan with manual steering.Quote:
Originally Posted by MadMonkey
Pointies will tell you to De-flower your rack.
I had a little coming out the reservoir at MSR, but I checked the level after each session and it never was down enough to really worry me.Quote:
Originally Posted by johnwag
The ones who don't AX might, but I'm with CosmoPower on this one; PS is a good thing on an AX car.;)Quote:
Originally Posted by Rogue
johnwag the POSII had the puking problem, turned out the old o-rings on the cap had seen better days replaced them and it limited the amount of puking.
As far as changing the fluid goes does anyone have a good way of doing it?? I drained the reservoir with a hose and refilled a few times to help refresh the fluid, it helped some but the Evolution driving school I took did more to solve the issue. ;)
I had a little coming out there, as well, but I had puddles coming out at Hallett. After checking the fluid, the dipstick measured near the bottom of the grid.Quote:
Originally Posted by Titus
Considering the age of my car, that's a good idea. I would like to put some synthetic fluid with a high boiling point in its place.Quote:
Originally Posted by POS Racing