Printable View
The rear support plates cover the ABS holes completely. Was yours a Sport bar? If so, then this is very peculiar. I mean seriously, I even used part of the ABS line hole for one of the rear support bolts. All I had to do was drill it out a little.
I had to disconnect the ABS harness and pull the wire out of the hole before I even set the bar in the car. It would completely have crushed the wire.
S.
Don't forget you're comparing an '04 to a '96. Just a thought.
There ya go! :alien:Quote:
Originally Posted by sammm
S.
Make sure you use grommets for ANY hole you reroute wires through!!!
You don't want to have the wires cut in 2 or insulation cut through & the wires grounded out.
RJ
Thanks. The ABS wires have a plastic sleeve already because Mazda routes them up through the body. That's actually why I need precisely a 3/4" drill bit: to match the hole size and allow the sleeve to seat properly.
You guys are so wonderful... :drunken:
S.