Suspension help 91 NA

So, I installed my new FM 2.5 coil over set up, which lowered the car a little. Then reinstalled my RB front sway bar with their end links adjusted all the way down, or as short as they would go. Of course all this was done with the suspension hanging. When I took it to the alignment shop they called and said the sway bar was touching the upper control arm. I had them just disconnect the sway and get the alignment done.

Tonight I modified the end links so they are a little shorter. With the front on ramps and the rear on jack stands, I have approximately 1/2" clearance between the sway and the upper A arm.

What do you guy's think? Is this plenty of clearance or is it back to the drawing board?

Which RB bar are you running? Part number.

I will have to check. I do know it's the hollow one

Part# 54104

Half inch clearance should be plenty.

Thanks Steve.

I kinda thought it was okay.

I will be at the AutoX school and AutoX, in Mineral Wells, this weekend, so that should tell the tale.

That's the correct bar, so it should work. I agree with Steve.

Thanks guys